350-801 Certification Exam Dumps Questions in here [Nov-2023]
Updated 350-801 Exam Practice Test Questions
Cisco 350-801 (Implementing and Operating Cisco Collaboration Core Technologies) Certification Exam is an industry-recognized certification that tests the candidate's knowledge and skills in implementing and operating Cisco Collaboration Core Technologies. Implementing and Operating Cisco Collaboration Core Technologies certification exam is a part of the Cisco Certified Network Professional (CCNP) Collaboration certification. Candidates who pass 350-801 exam will demonstrate their competency in implementing and operating Cisco Collaboration solutions including Cisco Unified Communications Manager (UCM), Cisco Unity Connection, Cisco Unified Contact Center Express (UCCX), and Cisco Meeting Server.
Cisco 350-801 exam, also known as Implementing and Operating Cisco Collaboration Core Technologies, is a certification exam designed for IT professionals who specialize in Cisco collaboration solutions. 350-801 exam aims to test the candidate's knowledge and skills in implementing and operating core technologies of Cisco collaboration solutions, including Cisco Unified Communications Manager, Cisco Unity Connection, Cisco Collaboration Endpoints, and Cisco TelePresence Management Suite.
NEW QUESTION # 145
Refer to the exhibit. An administrator must replace the T1 card with an E1 card.
What is the correct configuration if the administrator was asked to configure 12 time slots?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 146
On which Cisco Unified Communications Manager nodes can the TFTP service be enabled?
- A. Any node
- B. Only nodes that have Cisco Unified CM service enabled
- C. Any subscriber nodes
- D. Any two node
Answer: A
NEW QUESTION # 147
A company has an excessive number of call transfers to local and long-distance PSTN from Cisco Unity Connection voicemail. Which action in the Cisco Unity Connection restriction table resolves this issue?
- A. Create a custom restriction table *********** and block it.
- B. Block PSTN patterns on Default Transfer, Default Outdial, and Default System Transfer.
- C. Implement password complexity on voicemail boxes to prevent accounts from being compromised.
- D. Create a custom restriction table ??????????? and block it.
Answer: B
NEW QUESTION # 148
An engineer is configuring IP telephony. The network relies on DHCP to provide TFTP server addresses to the endpoints. Policy requires the endpoints to receive two server addresses. Which DHCP option must be configured?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 149
What are two access management mechanisms in Cisco Webex Control Hub? (Choose two.)
- A. Active Directory synchronization
- B. attribute-based access control
- C. multifactor authentication
- D. Client ID/Client Secret
- E. single sign-on with Google
Answer: A,C
Explanation:
The correct answers are A and B.
The two access management mechanisms in Cisco Webex Control Hub are multifactor authentication and Active Directory synchronization.
Multifactor authentication is a security measure that requires users to provide two or more pieces of evidence to verify their identity. This can include something they know, such as a password, and something they have, such as a security token.
Active Directory synchronization is a process that allows Cisco Webex Control Hub to automatically synchronize user accounts from an Active Directory domain. This can simplify user management and provide users with single sign-on access to Cisco Webex Control Hub and other applications.
NEW QUESTION # 150
What is the traffic classification for voice and video conferencing?
- A. Voice is classified as CoS 4, and video conferencing is CoS 5.
- B. Video conferencing is classified as CoS 1, and voice is CoS 2.
- C. Voice and video conferencing are both classified is CoS 3.
- D. Voice is classified as CoS 5, and video conferencing is CoS 4.
Answer: C
NEW QUESTION # 151
Refer to the exhibit.
An administrator is attempting to register a SIP phone to a Cisco UCM but the registration is failing. The IP address of the SIP Phone is 10.117.34 222 and the IP 1 address of the Cisco UCM is 10.0.101.10. Pings from the SIP phone to the Cisco UCM are successful. What is the cause of this issue and how should it be resolved?
- A. An network device is blocking TCP port 5060 from the SIP phone to the Cisco UCM. This device must be reconfigured to allow traffic from the IP phone.
- B. DNS lookup for the Cisco UCM FQDN is failing. The SIP phone must be reconfigured with the proper DNS server.
- C. The certificates on the SIP phone are not trusted by the Cisco UCM. The SIP phone must generate new certificates.
- D. An NTP mismatch is preventing connection of the TCP session between the SIP phone and the Cisco UCM. The SIP phone and Cisco UCM must be set with identical NTP sources.
Answer: A
NEW QUESTION # 152
Refer to the exhibit.
Endpoint A calls endpoint B.
What is the only audio codec that can be used for the call?
- A. PCMA/8000
- B. G7221/16000
- C. G277/8000
- D. Telephone-event/8000
Answer: C
NEW QUESTION # 153
Refer to the Exhibit.
Which command is required to allow this media resource to handle Video Media streams?
- A. associate application Cisco Unified Border Element
- B. video codec h264
- C. codec pass-through
- D. maximum sessions hardware 50
Answer: C
NEW QUESTION # 154
Refer to the exhibit.
An administrator is attempting to register a SIP phone to a Cisco UCM but the registration is failing. The IP address of the SIP Phone is 10.117.34 222 and the IP 1 address of the Cisco UCM is 10.0.101.10. Pings from the SIP phone to the Cisco UCM are successful. What is the cause of this issue and how should it be resolved?
- A. An network device is blocking TCP port 5060 from the SIP phone to the Cisco UCM. This device must be reconfigured to allow traffic from the IP phone.
- B. DNS lookup for the Cisco UCM FQDN is failing. The SIP phone must be reconfigured with the proper DNS server.
- C. The certificates on the SIP phone are not trusted by the Cisco UCM. The SIP phone must generate new certificates.
- D. An NTP mismatch is preventing connection of the TCP session between the SIP phone and the Cisco UCM. The SIP phone and Cisco UCM must be set with identical NTP sources.
Answer: A
NEW QUESTION # 155
Refer to the exhibit.
A customer submits this output, captured on a Cisco IOS router. Assuming that an MGCP gateway is configured with a ISDN BRI interface, which BRI changes resolve the issue?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: D
NEW QUESTION # 156
An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit has received to its previous version. What must the administrator do to prevent this from happening again?
- A. Assign a phone security profile with secure SIP.
- B. Confirm the phone load name in the phone configuration.
- C. Set the prepare cluster for rollback to pre-8.0 enterprise parameter to true.
- D. Assign a universal device template to the phone.
Answer: B
Explanation:
Section: Infrastructure and Design
NEW QUESTION # 157
What are two differences between media flow-around and media flow-through on cisco unified Border element? (Choose two.)
- A. When using media flow-through, the call signaling goes through the Cisco Unified Border Element, but media is not passed through it.
- B. When using media flow-through, the call signaling and media are passed through the Cisco Unified Border Element
- C. When using media flow-around. the call signaling goes through the Cisco Unified Border Element, but media is not passed through it
- D. When using media flow-around, both call signaling and media do not go through the Cisco Unified Border Element
- E. When using media flow-through, call signaling goes through the Cisco Unified Border Element but media does not
Answer: B,C
NEW QUESTION # 158
What happens to voice packets from a Cisco 8845 IP phone in the QoS trust boundary?
- A. The phone and access layer switch negotiate the classification of packets.
- B. The voice packets are classified by the phone, and the classification is accepted.
- C. The voice packets are not trusted, and the access layer switch reclassifies the packets.
- D. Cisco UCM determines how the voice packets are classified.
Answer: D
NEW QUESTION # 159
Refer to the exhibit.
Refer to the exhibit. An engineer configures ISDN on a voice gateway. The provider confirms that the PRI is configured with 10 channels the engineer ordered and is working from the provider side, but the engineer cannot get a B-channel to carry voice. The rest of the configuration for the serial interface and voice network is functioning correctly. Which actions must be taken to carry voice?
- A. The engineer must manually revert the order of using the channels.
- B. The engineer used a T1 interface but must use an E1 interface.
- C. The engineer must activate the controller card on the voice gateway before configuring the device.
- D. The pri-group timeslots command must be 0-9 for the 10 channels because all values on a router start with 0.
Answer: C
NEW QUESTION # 160
Refer to the exhibit.
An administrator must fix the SRV records to ensure that server1.sample.com is always contected first from the three servers. Which solution should apply to resolve this issue?
- A. Priority = 5, Weight = 70
- B. Priority = 100, Weight = 90
- C. Priority = 10, Weight = 5
- D. Priority = 10, Weight = 10
Answer: A
NEW QUESTION # 161
A collaboration engineer troubleshoots issues with a Cisco IP Phone 7800 Series. The IPv4 address of the phone is reachable via ICMP and HTTP, and the phone is registered to Cisco UCM However the engineer cannot reach the CU of the phone.
Which two actions in Cisco UCM resolve the issue? (Choose two)
- A. Disable Web Access under Product Specific Configuration Layout in Cisco UCM
- B. Enable FIPS Mode under Product Specific Configuration Layout in Cisco UCM
- C. Set a username and password under Secure Shell information in Cisco UCM
- D. Enable SSH Access under Product Specific Configuration Layout in Cisco UCM
- E. Enable Settings Access under Product Specific Configuration Layout in Cisco UCM
Answer: C,D
NEW QUESTION # 162
Which characteristic of distributed class-based weighted fair queueing addresses jitter prevention?
- A. It provides additional granularity by allowing a user to define custom classes
- B. It uses a priority queue for voice traffic to avoid jitter
- C. It minimizes jitter by implementing a priority queue for voice traffic
- D. lt provides additional granularity by allowing a user to create classes
Answer: D
NEW QUESTION # 163
Which two steps are required for bulk configuration transactions on the Cisco UCM database utilizing BAT? (Choose two)
- A. A device template must be created in Cisco UCM.
- B. A server template must be created in Cisco UCM.
- C. A data file in Extensible Markup Language format must be uploaded to Cisco UCM
- D. A data file in Abstract Syntax Notation One format must be uploaded to Cisco UCM
- E. A data file in comma-separated values format must be uploaded to Cisco UCM
Answer: A,E
Explanation:
https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/9_0_1/CUCM_BK_C22BD805_00_ cucm-bulk-administration-guide_chapter_01.pdf
NEW QUESTION # 164
A network administrator deleted a user from the LDAP directory of a company. The end user shows as Inactive LOAP Synchronized User in Cisco Unified Communications Manager. Which step is next to remove this user from Cisco Unified Communications Manager?
- A. Wait 24 hours for the garbage collector to remove the user.
- B. Delete the user directly from Cisco Unified Communications Manager
- C. Execute a manual sync to refresh the local database and delete the end user.
- D. Restart the Dirsync service after the user is deleted from LDAP directory.
Answer: D
NEW QUESTION # 165
Drag and drop the SNMPv3 message types from the left onto the corresponding definitions on the right.
Answer:
Explanation:
NEW QUESTION # 166
What dialed number match this cisco UCM route pattern?
1[23]XX
- A. 1230 through 1239 only
- B. 1200 through 1300 only
- C. 1200 through 1399 only
- D. 12300 through 12399 only
Answer: C
NEW QUESTION # 167
Refer to the exhibit.
Refer to the exhibit. An engineer is troubleshooting this video conference issue:
*A video call between a Cisco 9971 in Region1 and another Cisco 9971 in Region1 works.
*As soon as the Cisco 9971 in Region1 conferences in a Cisco 8945 in Region2. the Regio1l endpoint cannot see the Region2 endpoint video.
What is the cause of this issue?
- A. Cisco 8945 does not have a camera connected.
- B. Maximum Audio Bit Rate must be increased.
- C. Maximum Session Bit Rate for Immersive Video Calls is too low.
- D. Maximum Session Bit Rate for Video Calls is too low.
Answer: D
NEW QUESTION # 168
Refer to the exhibit. An engineer configured NTP on Cisco UCM and runs the utils ntp status command from Cisco UCM CLI and receives an error message. How is this issue mitigated and fixed?
- A. Use an external NTP server and allow communication on port 53.
- B. Ensure that Cisco UCM can communicate with the NTP server on port 53 and have a Windows NTP server configured with NTPv3.
- C. Configure the NTP server to answer requests on port 443.
- D. Ensure that Cisco UCM can communicate with the NTP server on port 123 and have a Linux NTP server configured with NTPv4.
Answer: D
NEW QUESTION # 169
Which Cisco Unified Communications Manager feature is to determine the maximum bit rate for a call between two video-endpoints?
- A. transformations
- B. Partitions
- C. Locations
- D. Regions
Answer: D
Explanation:
Regions provide capacity controls for Unified Communications Manager multi-site deployments where you may need to limit the bandwidth for certain calls. For example, you can use regions to limit the bandwidth for calls that are sent across a WAN link, while maintaining a higher bandwidth for internal calls. You can use regions to limit the bandwidth for audio and video calls by setting the maximum bitrate for intraregional or interregional calls to whatever the region(s) can provide.
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/11_5_1/sysConfig/11_5_1_S U1/cucm_b_system-configuration-guide-1151su1/cucm_b_system-configuration-guide-
1151su1_chapter_0111.html
NEW QUESTION # 170
......
Final Thoughts
IT certifications can give you the much-needed flexibility enabling you to choose where you want to take your career. The Cisco 350-801 exam specifically stands out because it not only equips candidates with new skills but also qualifies them for a new certification. Get your career on track today by acing the test and enjoy the endless benefits.
Pass CCNP Collaboration 350-801 Exam With 390 Questions: https://dumpstorrent.exam4pdf.com/350-801-dumps-torrent.html
